Tandberg Data Magnum 224, Руководство по эксплуатации продукта, Страница: 185 / 278

A
UGUST
2007 M
AGNUM
224, S
TORAGE
L
IBRARY
T24,
OR
S
TORAGE
L
OADER
2U
167
R
EPLACING A
T
APE
D
RIVE
(
SAME CONFIGURATION
)
b. b. b. b. While holding the cables out of the way, slide the new tape drive into the
library, leaving it a short distance out to access the cables. Use care not to
damage the cables.
c.
c. c.
c. Connect the supplied serial cable (
S
) and the power cable (
P
) to the tape
drive. For routing instructions, see:
Full Height tape drive below
Second Half height tape drive on page 168
Single Half height tape drive on page 168
Full height tape drive :
Serial —Route the serial cable (
S
) under the tape drive carrier as shown here;
connect as shown in Figure 7-1 (FH serial cable routing).
Power
—Route the power cable over the tape drive carriers as shown here;
connect as shown in Figure 7-3 (FH power cable routing).
Tape drive Quantity
Install in this
opening...
Serial
connector
Internal
label
Half height
Second tape drive Top Top Drive 2
Single tape drive Bottom Bottom Drive 1
Full height Single tape drive Bottom Bottom Drive 1
Figure 7-9
Full height tape drive’s serial and power connectors
Serial cable ( S )
(route under carrier)
Do not use
middle connector
with full height
tape drive
Power cable ( P )
(route over carrier)