Tandberg Data Magnum 224, Руководство по эксплуатации продукта, Страница: 183 / 278

A
UGUST
2007 M
AGNUM
224, S
TORAGE
L
IBRARY
T24,
OR
S
TORAGE
L
OADER
2U
165
R
EPLACING A
T
APE
D
RIVE
(
SAME CONFIGURATION
)
c. c. c. c. Connect the supplied serial cable (
S
) and the power cable (
P
) to the tape
drives.
d.
d. d.
d.
Slide the tape drive the remaining distance into the library.
4.
4. 4.
4.
Completing the installation —
a. a. a. a. Locate the tape drive cover plate (see “Reference Illustrations” on
page 161 ). First, remove the SCSI plate, and then attach the tape drive
cover plate with the screws you removed earlier.
b. b. b. b. Reconfigure your library— You must reconfigure your library for your
backup application to recognize the new tape drive . See page 172 for
instructions.
R
EPLACING A
T
APE
D
RIVE
(
SAME CONFIGURATION
)
To replace a tape drive with a different tape drive of the same configuration
(half height to half height, or full height to full height), follow these steps.
1.
1. 1.
1.
Preparing for replacement —
a.
a. a.
a.
Power off the host.
b.
b. b.
b.
Power off the library (press the 0 on the back of the unit).
Figure 7-7
Upper half height tape drive cable routing
Power cable ( P )
Serial cable ( S )
Tape drive
(route over
carrier and
under the
power cable)
(route under carrier
and over serial cable)
carrier
Press the serial cable ( C ) down into the
carrier to prevent catching it between
the tape drive and the library.
!
! !
!
Important
The library requires both the SCSI cover plates and the tape
drive cover plates for ESD protection. Do not leave any
openings uncovered.
Do not connect the SCSI cables until after you reconfigure the
library.