Sun Microsystems Server X4-2, Руководство по установке

Страница: 107 / 208

Connecting to Oracle ILOM 93
Note –
Assigning a new static IP address to the device will end all active Oracle
ILOM sessions to the device. To log in again to Oracle ILOM, you will need to create
a new session using the newly assigned IP address.
Related Information
■
“Determining the IP Address of the Server SP” on page 85
■
“View or Modify an SP IPv4 Address” on page 88
Accessing the Host Console Through
Oracle ILOM
Connecting to the host console through Oracle ILOM enables you to perform actions
as if you were at the host. Connect to the host to perform the following tasks:
■
Access the server BIOS Setup Utility remotely.
■
Install an operating system on the server.
■
Configure an operating system on the server.
■
Configure or install other software on the server.
■
Access the Oracle System Assistant through Oracle ILOM.
For instructions, see the following sections:
■
“Set Mouse Mode” on page 94
■
“Access Remote Host Console Using the Oracle ILOM Web Interface” on page 94
Property and Set Property Value Description
Property:
state
Set Property Value:
set state=enabled
The IPv6 network state is enabled by default. To enable a
static IP address set this state to
enabled
.
Property:
pending_static_ipaddress
Set Property Value: set
pending_static_ipaddress/
<subnet mask
length_in_bits>
Type this command followed by the property value for the
static IPv6 address and subnet netmask that you want to
assign to the device.
IPv6 address example:
2001:DB8:
n : n
Property:
commitpending
Set Property Value:
set commitpending=true
Type
set commitpending=true
to commit changes.