Sun Microsystems Server X4-2, Руководство по установке

Страница: 93 / 208

Cabling the Server 79
If using Oracle ILOM, configure the system for the first time through the SER
MGT port. After initial configuration, you can set up communication between
the SP and host through the remote Ethernet interface.
3. For network access, connect an Ethernet cable between the server NET ports
(NET3-0) and the network to which the server will communicate.
Connecting Power Cords to the Server
This section describes how to connect power cords to the server and how to apply
power to the server for the first time.
■
“Connect the Power Cords” on page 79
Related Information
■
“Rear Cable Connections and Ports” on page 75
■
“Ethernet Ports” on page 77
▼
Connect the Power Cords
Caution –
Do not connect the power cords to the server until the you have made the
SP and host networking connections as described in “Attaching Data Cables to the
Server” on page 78 . The server includes a service processor (SP) that is used to
configure and boot the host system. Connecting the SP and host networking cables
first enables you to properly configure the host system and view SP messages.
1. For each installed power supply, connect one grounded server power cord to a
grounded electrical outlet.
Note – The server is equipped with two power supplies. Connect them to separate
power sources to provide power redundancy. The server can operate with one power
source; however, having only one power source reduces the redundancy.