Sun Microsystems Server X4-2, Руководство по установке

Страница: 104 / 208

90 Sun Server X4-2 Installation Guide • February 2014
Note – Ethernet ports NET2 and NET3 are nonfunctional in single-processor systems
and, therefore, cannot be used for sideband management.
->
set /SP/network/commitpending=true
The following table describes the network settings.
Related Information
■
“Determining the IP Address of the Server SP” on page 85
■
“View or Modify an SP IPv6 Address” on page 90
▼
View or Modify an SP IPv6 Address
To view or modify the IPv6 address currently assigned to the Oracle ILOM SP:
Property and Set Property Value Description
Property:
state
Set Property Value:
set state=enabled
The network state is enabled by default.
Property:
pendingipdiscovery
Set Property Value:
set pendingipdiscovery=static
To enable a static network configuration, set
pendingipdiscovery
to
static
.
By default,
pendingipdiscovery
is set to
dhcp
.
Property:
pendingmanagement port
Set Property Value:
set pendingmanagementport=
/System/SP/NET0
By default,
pendingmanagementport
is set
to the NET MGT port (
/System/SP/NET0
).
To enable sideband management, set
pendingmanagementport
to an available
10-Gigabit Ethernet port. Set
pendingmanagementport
to
/System/MB/NET
n , where n represents 3, 2,
1, or 0.
Note - Ethernet ports NET2 and NET3 are
nonfunctional in single-processor systems
and, therefore, cannot be used for sideband
management.
Property:
pendingipaddress
Set Property Value:
set pendingipaddress=
<ip_address>
Property:
pendingipnetmask
Set Property Value:
set pendingipnetmask=
<netmask>
Property:
pendingipgateway
Set Property Value:
set pendingipgateway=
<gateway>
To assign multiple static network settings,
type the
set
command followed by the
pending
command for each property value
(IP address, netmask, and gateway), then
type the static value that you want to assign.