Sun Microsystems Server X4-2, Руководство по установке

Страница: 91 / 208

Cabling the Server 77
Related Information
■
“Ethernet Ports” on page 77
■
“Attaching Data Cables to the Server” on page 78
■
“Connecting Power Cords to the Server” on page 79
Ethernet Ports
The server has four RJ-45, 10-Gigabit Ethernet (10GbE) network connectors, labeled
NET 3, NET 2, NET 1, and NET 0 from left to right on the server rear panel. Use these
ports to connect the server to the network.
Note – Ethernet ports NET 2 and NET 3 are nonfunctional in single-processor
systems.
The LEDs located above each NET port are Link/Activity (left) and Speed (right)
indicators for each port. The following table lists the Ethernet transfer rates and the
Speed LED color.
4 Ethernet ports (NET 3, NET 2, NET 1, NET
0) The four 10-Gigabit Ethernet ports enable you to connect the
system to the network. See
“Ethernet Ports” on page 77 for
more information.
Note -
Ethernet ports NET 2 and NET 3 are nonfunctional in
single-processor systems.
5, 6 USB ports (USB 0, USB 1) The two USB ports support hot-plugging. You can connect
and disconnect USB cables and peripheral devices while the
server is running, without affecting system operations.
7 Video port (VGA, DB-15) Use a 15-pin video cable to connect a VGA video device to the
server. Optionally, you can connect to the VGA port when
installing the operating system.
Connection Type IEEE Terminology Speed LED Color Transfer Rate
Fast Ethernet 100BASE-T Off 100 Mbits/sec
Gigabit Ethernet 1000BASE-T Amber 1,000 Mbits/sec
10 Gigabit Ethernet 10GBASE-T Green 10,000 Mbits/sec
No. Cable Port or Expansion Slot Description