Strasbaugh 6DS-SP, Руководство по эксплуатации

Страница: 1200 / 1562

STRASBAUGH, INC.
June 30, 2001 6DS-SP Software Ver 4.37.2 Page 18
Strasbaugh Confidential Information
Software Installation:
Introduction:
Software is installed by copying files from two floppy disks onto the machine's internal
computer. This computer is located behind the left front access door.
Important: Copying new software onto the machine will delete whatever software was
previously in the machine. However, calibration, setup, polish recipe, and conditioning recipe
files are not altered.
The following describes how to use Strasbaugh, Inc. 6DS-SP "INSTALL" utility disks which
will automatically install software.
Installing new software from floppy disks to the machine:
NOTE: Two diskettes are used to install the software.
1) If the "DOS" prompt "C:\QB45>" is not already showing on the screen, do the following:
- In the main menu, type
ALT+Q
(press the ALT and Q keys together).
This should cause the DOS prompt
“C:\QB45>”
to show.
2) Insert the "INSTALL DISK #1" into the machine's disk drive.
3) Type:
“A:INSTALL 4372”
and press
ENTER
- Files will automatically be copied from the disk to the machine.
- Remove the diskette when done.
4) Insert the "INSTALL DISK #2" into the machine's disk drive.
5) Type:
“A:INSTALL 4372”
and press
ENTER
- Files will automatically be copied from the disk to the machine.
- Remove the diskette when done.
6) Remove any floppy disk in the machine and turn the machine off and back on to start the
new software.
NOTE: When done saving or installing software, remove the floppy disk from the
computer disk drive. Always keep floppy disks in a cool dry place.