Still RX20 14-20, Оригинальное руководство пользователя

Страница: 448 / 600

Stopping the charging process manually
–
Briefly press the charging button (8) on the
truck plug.
The charging status display on the display-op-
erating unit goes out. The mains plug can now
be disconnected.
–
If the charging process needs to be started
again, pull out the truck plug and plug it
back in after approx. 2 seconds.
The charger starts a new charging process.
NOTE
There may be a delay of up to 60 seconds
before a new charging process starts.
Charging with an electrolyte circulation
pump
As an option, the on-board charger can be
equipped with an electrolyte circulation pump.
To adjust the charging characteristic curve
to the respective battery type, the authorised
service centre must install this pump and con-
figure this pump in the battery charger.
Using an electrolyte circulation pump reduces
the charging time of a lead-acid battery and
enables intermediate charging.
If the truck is equipped with an electrolyte
circulation pump, a battery designed for elec-
trolyte circulation must always be used. The
pump can be damaged without the counter-
pressure from the battery. The charger detects
an error as soon as the pressure drops during
the pumping process.
If a defect in the electrolyte circulation pump
or the air duct is detected, the battery charg-
er continues charging with a standard charg-
ing program without the electrolyte circulation
pump. The LED on the charger socket flashes
yellow/red. This indicates a fault.
NOTE
To mix the electrolyte in the battery, the elec-
trolyte circulation pump is switched on only
periodically.
8
6219_003-257

Operating
4
On-board charger
432 56368011501 EN - 04/2022 - 13