Section 12
PROPULSION SYSTEM
Subsection 02
(JET PUMP)
12-02-14
SMR2002-088_12_02A.FM
Bearing on impeller side must be 1.5 to 2.5 mm
(.060 - .100 in) inside reservoir measured from seal
seat. Refer to following illustration.
1. Seal seat
2. Stamped end of bearing
A. 1.5 - 2.5 mm (.060 - .100 in)
Apply Loctite 518 (P/N 293 800 038) to seal hous-
ing, all around outer diameter and on seal seat.
Properly insert seal on tool.
NOTE:
Apply synthetic grease on tool to ease seal
insertion.
Install seal with the spring toward the
outside
.
1. Spring of seal this side
CAUTION:
Prevent sealant from contacting any
needles of bearing.
Push on tool end with a press until tool flange con-
tacts housing.
1. Press on tool until it stops
Apply synthetic grease (P/N 293 550 010) between
seal lips.
1. Loctite 518 all around and behind
2. Spring of seal lip this side
F01J5YA
A
1
2
F01J1KA
1
F00J0CA
1
F01J1MA
1
2
www.SeaDooManuals.net
Содержание GTX 4-TEC 5573 2002
