Section 12
PROPULSION SYSTEM
Subsection 02
(JET PUMP)
SMR2002-088_12_02A.FM
12-02-11
Thrust Washer and Thrust Bearing
Visually inspect thrust washer
no. 32
, thrust bear-
ing
no. 33
and their contact surface. Check for
scoring, pitting, flaking, discoloration or other evi-
dence of wear. For best inspection, use a 7X mag-
nifying glass to check wear pattern.
TYPICAL
1. Worn roller (trunnion worn on end roller)
2. Good roller (cylindrical shape)
3. Look for scoring on retainer
NOTE:
When replacing either washer or bearing,
it is recommended to renew both.
Anti-Rattle Pusher
Check for melted plastic around metal pad. If so,
replace it.
Check for excessive wear of pad.
Seal
Carefully inspect seal lips. Make sure that lips are
not worn, distorted, cracked or show signs of any
other damage. Replace after 150 hours even if it
seems good.
OPAS Filter
OPAS filter is part of plastic elbow
no. 45
. Check
for cleanness. Replace or clean it as necessary.
ASSEMBLY
Plastic Elbow
Install plastic elbow no. 45 at 20° angle to the right.
It may exceed inside housing by 1.0 mm (.039 in).
It may be positioned up to 2.0 mm (.078 in) from
housing edge.
A. 20°
B. 2.0 mm (.078 in)
C. 1.0 mm (.039 in)
F01J52A
1
2
3
F08J05A
A
F18J0EA
B
C
www.SeaDooManuals.net
Содержание GTX 4-TEC 5573 2002
