Section 12
PROPULSION SYSTEM
Subsection 02
(JET PUMP)
SMR2002-088_12_02A.FM
12-02-13
Seal and Needle Bearing
Bearings
no. 30
and seal
no. 29
will be properly
installed in housing using bearing/seal installer
tool (P/N 295 000 107).
BEARING/SEAL INSTALLER TOOL
1. Seal side
2. Bearing side
For the bearing
on venturi side
use inner bearing
installer tool (P/N 529 035 609).
CAUTION:
Failure to use this tool will cause ma-
jor damage to the pump.
Impeller Side
Stamped end of bearings (showing identification
markings) must be located toward outside of hous-
ing.
Properly insert bearing on tool. Using an arbor press
only, push tool until tool flange contacts housing.
1. Stamped end this side
CAUTION:
Never hammer the bearing into its
housing.
1. Press on tool until it stops
2. Bearing
CAUTION:
These tools have been designed to
properly position bearings and seal, thus pro-
viding space for lubrication purposes. The tool
flanges allow this. If a different pusher type is
being used, components must be properly po-
sitioned as follows.
F01J4KA
2
1
F08B01A
F01J1HA
1
F00J0ZA
1
2
www.SeaDooManuals.net
Содержание GTX 4-TEC 5573 2002
