Section 05
ENGINE (4-TEC)
Subsection 07
(LUBRICATION SYSTEM)
05-07-4
SMR2002_071_05_07A.FM
7. Remove dipstick and read oil level. It should be
between marks.
1. Full
2. Add
3. Operating range
8. Otherwise, add oil up to have the level between
marks as required.
9. To add oil, unscrew oil cap. Place a funnel into
the opening and add the recommended oil to
the proper level. Do not overfill.
ENGINE PRESSURE TEST
NOTE:
The engine pressure test should be done
with a
warm engine
and the
recommended oil
.
Remove plug below oil filter housing.
Use oil pressure gauge (P/N 529 035 709) and hose
adaptor (P/N 529 035 652) and install where shown.
Start engine and read pressure at different RPM
as per following table.
1. Oil filter housing
2. Pressure test plug
NOTE:
Oil pressure switch works between 180 kPa
(26 PSI) and 220 kPa (32 PSI).
The engine oil pressure should be within the follow-
ing values.
If the engine oil pressure is out of specifications,
check the points described in TROUBLESHOOT-
ING section.
Reinstall plug.
Oil change
Engine in vehicle
NOTE:
If water is found in oil (oil will be milky),
refer to submerged engine in MAINTAINANCE
section and follow the procedure to flush it.
Bring engine to its normal operating temperature.
CAUTION:
Never run engine without supplying
water to the exhaust cooling system when wa-
tercraft is out of water.
F18D05A
1
2
3
OIL PRESSURE TEST
ENGINE RPM
PRESSURE kPA (PSI)
Idle (cold)
300 - 400 (44 - 58)
Idle (at 80°C (176°F)
min. 160 (23)
4000 - 7500
300 - 400 (44 - 58)
1
F18G03A
2
www.SeaDooManuals.net
Содержание GTX 4-TEC 5573 2002
