Section 04
ENGINE (DI)
Subsection 06
(BOTTOM END)
SMR2002-063_04_06A.FM
04-06-11
1. Seal lip in crankcase recess
Drive Pin
Make sure drive pins
no. 6
of bearings are proper-
ly installed in crankcase recesses at assembly.
1. Drive pins
Counterbalance Shaft
Install bearing
no. 31
and washer
no. 32
.
When installing seals
no. 17
, apply a light coat of
Molykote 111 on seal lips.
Prior to installation, place bearings
no. 15
into a
container filled with oil, previously heated to 75°C
(167°F). This will expand bearings and ease their
installation.
Reinstall counterweights
no. 16
using a press and
take care to align index marks previously traced.
Crankshaft and Counterbalance Shaft
Install crankshaft
no. 3
first in crankcase.
After crankshaft installation, install counterbal-
ance shaft
no. 13
. Make sure to properly index
crankshaft and counterbalance shaft by aligning
marks of gears.
CAUTION:
Marks on the crankshaft and coun-
terbalance shaft must be aligned, otherwise en-
gine will vibrate and premature wear will occur.
1. Marks must be aligned
Turn by hand the crankshaft and counterbalance
shaft. Make sure they do not interfere with the
crankcase.
Properly position bearing
no. 31
and washer
no. 32
. Ensure to position lubrication hole on top
(
if so equipped
).
1. Bearing
2. Washer in crankcase groove
3. Lubrication hole on top (
if so equipped
)
F06D1LA
1
F00D0OA
1
F06D1MA
1
3
F12R16A
2 1
www.SeaDooManuals.net
Содержание GTX 4-TEC 5573 2002
