Section 05
ENGINE (4-TEC)
Subsection 07
(LUBRICATION SYSTEM)
SMR2002_071_05_07A.FM
05-07-13
Install the coolant/oil pump shaft using the rotary
seal pusher (P/N 529 035 823) on the opposite
side to support the rotary seal. Use the oil seal
guide (P/N 529 035 822) with a press.
1. Oil seal guide
2. Coolant/oil pump shaft
1. Coolant/oil pump shaft with oil seal guide
2. Rotary seal pusher
Tighten oil pump cover screws and torque to 10 N•m
(88 lbf•
in
). Apply Loctite 243 on threads.
Final Test
After engine is completely reassembled, start en-
gine and make sure oil pressure is within specifi-
cations.
OIL SUCTION PUMP
The oil suction pump is located on the front side
of the engine at the bottom of the oil separator.
Removal
– Remove blow-by ventilation hose
no. 7
.
1. Blow-by ventilation hose
– Disconnect wiring harness from blow-by pres-
sure switch
no. 9
and blow-by valve
no. 8
.
– Detach air silencer from throttle body.
– Disconnect battery cables and vent tube then
remove battery. Refer to BATTERY in CHARG-
ING SYSTEM section for proper procedures.
– Remove retaining screws
no. 42
.
– Place rags under cover to prevent spillage. If
spillage occurs, clean immediately with the pul-
ley flange cleaner (P/N 413 711 809) to prevent
stains.
– Remove oil suction pump housing with oil sep-
arator.
1
R1503motr142A
2
2
R1503motr143A
1
WARNING
Wear safety glasses and work in a well venti-
lated area when working with strong chemi-
cal products. Also wear suitable non-absor-
bent gloves to protect your hands.
1
R1503motr133A
www.SeaDooManuals.net
Содержание GTX 4-TEC 5573 2002
