Section 4: Operation and Configuration
TG3 Series Service Manual
Page 4-39
4.12 TEST PRINT MODE
(
Cont’d)
Item name to be printed
Description
Character Pitch or
Char. Pitch
Character pitch setting.
For proportional pitch, “Proportional” will be printed.
For fixed pitch, “Fixed” will be printed.
Print Method
Print method.
For thermal transfer printing, “Thermal Transfer” or “Transfer” will
be printed. For direct thermal printing, “Direct Thermal” or “Direct”
will be printed.
Reflective Sensor
Low [Lo<1.0] x.x(V)
High [0.8<Hi-Lo] x.x(V)
Slice Level Auto
This information will be printed when reflective sensor is enabled.
If “Low” is not [Low < 1.0], “Low” will be indicated in reverse colors.
If “High” is not [0.8 < (High-Low)], “High” will be indicated in reverse
colors.
Transmissive Sensor
Low [0.2<Lo<1.0] x.x(V)
High [0.8<Hi-Lo] x.x(V)
Slice Level Auto
This information will be printed when transmissive sensor is enabled.
If “Low” is not [0.2 < Low < 1.0], “Low” will be indicated in reverse
color.
If “High” is [0.8 < (High-Low)], “High” will be indicated in reverse
colors.
Head Check
The setting of head check function.
“None” will be printed when this function is off. When this function
is enabled and it is checking the actual printable area, “Normal” will
be printed.
For checking barcode print area, “Barcode” will be printed.
Check P-Size
The setting of paper size check function.
“Enabled” will be printed when this function is on. If not, “Disabled”
will be printed.
Calendar
Calendar display. If calendar IC is not installed in the printer,
“None” will be printed.
Calendar format is “YY/MM/DD/HH/MM”.
Calendar Check or Check
The setting of calendar check.
“Enabled” will be printed if calendar check is on. If not, “Disabled”
will be printed.
Note that this information will not be printed without installing the
calendar IC.
Command Error or
Cmd Err
The setting of command error display.
“Error” will be printed if this setting is enabled. If not, “Warning” will
be printed.
Protocol Code or
P-Code
Protocol code setting.
For standard protocol, “Standard” will be printed. For non standard
protocol, “Non Standard” will be printed.
Also, the protocol code stored in the printer will be printed.
Euro Code
Euro code setting.
DSW1
Prints DSW setting on CONT board (Main PCB).
DSW2
When RS-232C interface board is connected, the DSW information
on the interface board will be printed.
Содержание TG308
