SATO TG308, Руководство по обслуживанию

Страница: 233 / 252

Section 8: Appendix
TG3 Series Service Manual
Page 8-3
8.1 OPTIONAL ACCESSORIES - STACKER (Cont’d)
8.1.2 To install the Stacker
1.
Position the Stacker with the alignment plate attached, to
the front of the printer and slot the other end of alignment
plate to the base of printer.
2.
Connect the built-in cable from the Stacker to the
EXT
connector on the printer.
3.
Adjust the
Tag Stop
for the length of the tag.
4.
Adjust the
Tag Edge Guide
to the width of the tag.
5.
Turn the printer on and make sure the cutter is enabled and
the tags aligned for printing.
Note:
If the tag sensors are not aligned properly, the printer feeds
out a length of tag stock without cutting it, as it is attempting
to determine the tag pitch (length). Temporarily move the
Stacker unit to one side if this occurs, until the sensors are
correctly set and the tags are at the proper position.
6.
Send the print job to the printer and let it cut and stack a few
tags. The temporarily stop the printer by pressing the
ONLINE
button and check to make sure the tags are being
stacked under the
Tag Hold Down
and that the
Tag Stop
and
Tag Edge Guide
are properly set.
7.
When proper operation has been verified, place the printer back ON LINE by pressing the
ONLINE
button
again to finish the print job.
8.
The printer will automatically stop and go OFFLINE when the Stacker is full. When this happens, remove
the tags and finish the print job by pressing the
ONLINE
button to place the printer back ON LINE.
Tag edge
guide
Tag stop