Section 7: Replacement Procedures
Page 7-30
TG3 Series Service Manual
7.18 REPLACING JUMP HOLE SENSOR (cont’d)
To replace Jump hole sensor (lower) board
10.
Slide the Media guide knob to the widest. Remove two
screws
(10) securing the
Bracket (Jump sensor)
(11) to the Media route frame.
11.
Disconnect the
Lower Jump hole wiring harness
and withdraw the
Bracket (Jump sensor)
(11) with the
sensor board attached.
12.
Remove two
screws
(12) securing the
Lower Jump hole sensor board
(13) and replace it as necessary.
13.
Reverse the above procedures for reassembly.
Insert the
wiring harness
firmly and arrange the
wiring harnesses
to ensure that they are not pinched
during installation.
14.
After replacement, adjust the Jump hole sensor condition based on
Section 6.9.5 Jump hole Sensor
Sensitivity Adjustment
.
10
12
13
11
13
11
Содержание TG308
