Section 4: Operation and Configuration
TG3 Series Service Manual
Page 4-1
OPERATION AND CONFIGURATION
Before using the printer, it is best to read this manual thoroughly first. Otherwise, you may disturb default
settings upon which the instructional procedures in this manual are based.
The printer may be manually configured via the
ONLINE
,
FEED
,
CUTTER
,
EJECT
,
FUNCTION
,
PAPER
and
arrow buttons with the LCD display on the operator panel of printer. All of the printer’s buttons are used either
singularly, or in conjunction, to perform configuration activities.
Many of these settings can also be controlled via software commands and in case of conflict between
software and control panel settings, the printer will always use the last valid setting. If you load a label job that
includes software settings and then enter a new setting via the LCD panel, the manually set values will be
used by the printer. If you set the values manually and then download a job with software settings, the
software settings will be used.
Содержание TG308
