SATO TG308, Руководство по обслуживанию

Страница: 246 / 252

Section 8: Appendix
Page 8-16
TG3 Series Service Manual
8.9 TAG SORTING METHOD (Cont’d)
8.9.2 Separator (Cont’d)
After tag discharging motion, two tags, which are about 0.08” (2 mm) longer and shorter than usual, will be
issued.
Considering the above condition, 0.08” (2 mm) at the bottom of the tag will be an unprintable area when using
the separator. Make sure to check the tag length when designing the tag layout.
The tag will not be discharged by pressing the
EJECT
button after completing the sorting operation.
If an error occurs (e.g. paper end) during sorting operation, the tags may not be sorted properly.
8.10 PAPER END
8.10.1 End Mark
An end mark will be printed on the tag when paper end error or ribbon near end error occurs. This mark
enables the users to identify valid tag (QTY subtraction) and invalid tag (QTY does not change) at the time of
having such print errors, and the black box will be printed on the invalid tag.
When the cutting motion is activated, an end mark will be printed regardless of position where an error
occurred (within 0.47” or 12 mm).
This 0.47” (12 mm) is a preset value. Therefore, an end mark may or may not be printed, depending on the
tag size and the data to be printed.
Usual tag
2mm (0.08”)
Unprintable
First sorted tag
(2mm, 0.08” longer)
First sorted tag
(2mm, 0.08” shorter)
10mm
(0.4”)
12mm or more
Drawing range
Valid tag Invalid tag
14mm
(0.55”)
Position of
Error occurrence
12mm (0.47”) or
less
Position of
Error occurrence