SATO TG308, Руководство по обслуживанию

Страница: 170 / 252

Section 6: Checks and Adjustment Procedures
Page 6-32
TG3 Series Service Manual
6.11 SENSOR CHECKS
6.11.1 To check Ribbon End
Note:
There is no need to perform step 2 to step 4 if the printer is still in the default Thermal Trans-
fer mode.
1.
Press the
ONLINE
button in online mode state to go offline.
2.
Press the
FUNCTION
button to enter the Mode Selection screen. Use the /
arrow
and the
/ arrow
buttons to select ADVANCED MODE and press
the
FEED
button several times to display the PRINT METHOD screen.
3.
Select
TRANSFER
(Thermal transfer) with the /
arrow
buttons. Press
the
FEED
button to save changes.
4.
After that, press the
FEED
button several times to return the icon display.
5.
Make sure the ribbon end error occurs when you press the
FEED
button
while no ribbon is loaded.
6.
If no error indicate for above specified operations, check the connector
connection. If there is nothing wrong with the connection, the sensor needs
to be replaced.
7.
Refer to
Section 7.21 Replacing Ribbon Sensor
of this manual for Ribbon
Sensor Replacement instructions.
6.11.2 To check Head Open sensor and Lid Latch Sensor
1.
Ensure the printer is in
ONLINE
mode.
2.
Latch and unlatch the print head assembly to make sure to have a head open error is generated.
3.
Then press the purple Lid Latch lever to open and close the Lid Latch. Make sure a lid latch open error
occurs.
4.
If the sensor is faulty, refer to
Section 7.20 Replacing Head Open Sensor
or
Section 7.22 Replacing
Lid Latch Sensor
of this manual accordingly for replacement instructions.