SATO TG308, Руководство по обслуживанию

Страница: 67 / 252

Section 4: Operation and Configuration
TG3 Series Service Manual
Page 4-27
4.9 ADVANCED MODE (Cont’d)
ADVANCED MODE
Menu Description
Specifying the printer motion right after changing the reference position by the
<#> command.
STOP
: Pauses printing operation after changing the reference position.
CONTINUE
: Continues printing operation after changing the reference
position.
The initial value is CONTINUE.
* This setting is enabled only when paper type is set to tag and the cutter is
ON.
The printer can be set to perform a check of the print head when printing each
label.
ENABLE
: Head check is ON
Select ENABLE and press
FEED
button will proceed to HEAD CHECK menu.
DISABLE
: Head check is OFF
Select DISABLE and press
FEED
button will proceed directly to SET
CALENDAR menu (if calendar IC is installed) or SELECT LANGUAGE menu.
The initial value is DISABLE.
If Head Check has been ENABLE, you can specify the print head checking to
be performed unconditionally, or only when barcodes are being printed.
NORMAL
: Head check is performed on the entire print head.
BARCODE
: Head check is performed only on position where barcodes are
being printed.
The initial value is NORMAL.
This screen is displayed only when HEAD CHECK is set to ENABLE.
Selecting the calendar setting.
YES
: The printer enters date and time setting mode.
NO
: Skip this setting and proceed to the SELECT LANGUAGE menu.
The initial value is NO.
This screen is displayed only when calendar IC is installed.
Set the Year/Month/Date and then set the time in 24 hour format. The high-
lighted cursor indicates the digit is active for adjustment.
Press
/ arrow
buttons to change the setting value and press
/ arrow
buttons to move the cursor to next digit. Press
FEED
button to enter the set-
ting.
Enter the date and time twice. When the entered value of both screens match,
it goes to the next screen after saving the value. If not, the printer beeps and
goes back to the first entry display. The number of entries is indicated on the
right side of display.
This screen is displayed only when YES was selected in SET CALENDAR.
Enabling/Disabling the calendar check function.
ENABLE
: Calendar check is ON
DISABLE
: Calendar check is OFF
The initial value is ENABLE.
This screen is displayed only when YES was selected in SET CALENDAR.