Section 7: Replacement Procedures
TG3 Series Service Manual
Page 7-19
7.11 REPLACING MAIN (CONT) PCB AND CALENDAR IC (cont’d)
6.
If you need to install or replace the
Calendar IC
(10), remove the defect
Calendar IC
from the
IC socket
and carefully install the
Calendar IC
onto the
IC socket
. Make sure the dimple mark of
Calendar IC
and
the notch of the socket are facing the same direction as shown below.
7.
Reverse the above procedures for reassembly. Arrange all the wiring harnesses to ensure that they are not
pinched during installation.
Note:
Each of the wiring harness connectors are different from all others to ensure proper matching.
8.
After replacement of the Main PCB, perform the following adjustment procedures.
Refer to the Adjustment Procedures section of this manual for the procedures listed below.
1. All clear function
Refer to
Section 6.3 Counter Clear Mode
.
2. Checking ribbon end
Refer to
Section 6.11.1 To check Ribbon End
.
3. Head open sensor setting
Refer to
Section 6.11.2 To check Head Open sensor and Lid Latch Sensor
.
4. Adjustment of sensor level
Refer to
Section 6.9 Adjusting and Checking Sensors
.
5. Adjustment of print darkness
Refer to
Section 6.12 Adjusting Print Darkness
.
6. Offset setting
Refer to
Section 6.14 Adjusting Factory Offset
.
7. Adjustment of pitch
Refer to
Section 6.6 Adjusting Pitch Offset
.
8. Adjustment of cutting position
Refer to
Section 6.7 Adjusting Cut Offset
and
Section 6.10 Adjusting Cutter Sensors
.
If the Calendar IC is installed, set the desired time and date in ADVANCE mode as describe in
Section
6.15 Calendar Setting
.
Notch
Dimple
10
9
Содержание TG308
