Section 6: Checks and Adjustment Procedures
TG3 Series Service Manual
Page 6-45
6.21 ADJUSTING OPTIONAL STACKER MOTOR TIMING BELT TENSION (ST-TG3)
Required tool:
Phillips head screwdriver, tension gauge 2.20 pounds (1kg)
Measurement
:
1.
Place the tension gauge on the timing belt nearly in the middle of motor pulley shaft and feed roller pulley
shaft.
2.
Push the tension gauge against the belt and measure the belt tension when the belt gets deflected 1mm.
Adjustment:
1.
Loosen the two
screws
of
motor
.
2.
Move the motor mounting position left and right for adjustment.
3.
If the timing belt tension cannot be adjusted by the procedure above, replace the
stacker timing belt
based on the procedure,
Section 7.28 Replacing Optional Stacker Timing Belt (ST-TG3)
of this manual.
CRITERIA
5.29 to 7.05 ounces (150 to 200g)
Tension gauge
Measure the belt tension when pushing
the belt 1mm
Set screw of motor
Belt position before deflection
Содержание TG308
