SATO TG308, Руководство по обслуживанию

Страница: 149 / 252

Section 6: Checks and Adjustment Procedures
TG3 Series Service Manual
Page 6-11
6.8 ADJUSTING BACKFEED OFFSET
This setting adjusts the backfeed distance after or before a print out.
1.
Enter to MAINTENANCE MODE, select SERVICE MODE and then press
FEED
button. Refer to
Section 4.14 Maintenance Mode
for more details.
2.
Press the
/ arrow
buttons to select BACKFEED OFFSET on the
SERVICE MODE screen, and press the
FEED
button. The BACKFEED
OFFSET screen appears.
Backfeed distance can be adjusted for each media type.
3.
Press the /
arrow
buttons to select the media type. Press
/ arrow
buttons to enter the value within the range of ±00 to 99 dots.
See the table below for the media type corresponding to the printer model.
4.
Press the
FEED
button to save the value.
5.
Perform the test print to see if tags or labels are backfeed properly.
Media Sensor TG308 TG312
Tag Center hole +00 +00
Side hole +00 +00
Edge +00 +00
I-Mark +00 +00
Label Gap +00 +00
I-Mark +00 +00
Others Not sensor +00 +00