SATO TG308, Руководство по обслуживанию

Страница: 171 / 252

Section 6: Checks and Adjustment Procedures
TG3 Series Service Manual
Page 6-33
6.12 ADJUSTING PRINT DARKNESS
6.12.1 To adjust the Print Darkness in Adjustment Mode
1.
Press the
ONLINE
button in online mode state to go offline. Pressing both
the
FUNCTION
and the
arrow
buttons at the same time will switch the
printer to Adjustment mode.The PITCH POSITION screen is displayed.
2.
Press
FEED
button twice to display the DARKNESS screen.
3.
Press
/ arrow
buttons to set the desired value and press
FEED
button to
save the setting and proceed to the next Adjustment screen.
The setting range is between 00 and 99, and the initial value is 50.
Note:
It is not advisable to set the print darkness to the higher position as a darker
print-out requires the print head to operate in a higher temperature. Operat-
ing in high temperature may damage the print head in a long run.
6.12.2 To adjust the Print Darkness in User Mode
1.
After turning on the power, press the
ONLINE
button to go offline. Press the
FUNCTION
button to enter the mode menu selection screen.
2.
Press the / /
/ arrow
buttons to select
USER MODE
.
3.
When USER MODE screen is displayed, press the
FEED
button to enter to
User mode for adjustment.
Note:
PASSWORD may prompt on the display if SET PASSWORD is set to ON in
the Service mode. Please refer to
Section 4.15 Service Mode
for details in
password inputting.
4.
Press the
FEED
button repeatedly until PRINT DARKNESS screen is
displayed.
5.
Press /
arrow
buttons to select the Print Darkness level and press
FEED
button to save the setting.
Setting value can be set from 1 (lightest) to 3 (darkest). The default setting is
2.