Section 2: Basic Specifications
Page 2-8
TG3 Series Service Manual
2.2 OPTIONAL ACCESSORIES SPECIFICATIONS
LARGE-SIZED STACKER SPECIFICATIONS
Model name
ST-TG3
Maximum stack height
5.9” (150 mm) (Paper thickness 0.01” (0.26 mm), approximately 500 tags)
Tag feed speed
9.8” per second (250 mm/second)
Media Type
Tag only (Use of label is not acceptable)
* Refer to the Consumable Specifications for more details.
Make sure the tag size meets the following conditions.
Media Size
Tag
Width: 1.3” to 3.3“ (32 to 83 mm)
Pitch: 1” to 5.9” (25 to 150 mm)
* Use the optional weight when the tag length is 3.5” (90 mm) or greater.
* Use the optional spacer when the length of laminated tag and glossy tag are 3.5”
(90 mm) or more.
Thickness
Tag: 0.006” to 0.013“ (0.159 to 0.33 mm)
Some restrictions may apply to the tag size due to tag curling when the diameter of
tag roll core is 3 inches (76.2 mm).
Tag pressure
Weight load type
Sensor
Movable tag full sensor
Outputs the “stacker full” signal to the EXT (the printer) at the time of error
occurrence.
Communication
(Connection)
Input
: Amphenol 14-pin Male (EXT connector connection)
* Connecting with the computer (Rewinder and daisy connection inside)
EXT terminal (for handshake):
#3 (Input): Winding motor control
#5 (Output): Rewinder full + stacker full
#6 (Input): Stacker motor control
Output
: Amphenol 14-pin Female (EXT connector connection)
* Connecting with the rewinder (RWG500/RWS300)
EXT terminal (for handshake):
#3 (Input): Winding motor control
#5 (Output): Rewinder full
Power supply
Supplied from the printer unit (EXT connector).
EXT terminal:
# 2 : GND
# 12 : DC+24V
# 13 : DC+5V
Motor
Stepping motor (Interfaces with the printer)
2-phase unipolar type stepping motor
Dimensions
W 8.6” X D 9.6” X H 11.8” (W 219 X D 245 X H 300 mm)
Weight
7.5” (3.4 kg)
Fixation (Installation) method
Simple fixation by joint plate.
* Can be set by the users.
Accessories
Tag stopper, Joint plate, Optional weight (For the tag length of 90 mm or more),
Optional spacer with magnet (Use the optional spacer when the length of laminated
tag and glossy tag are 90 mm or more), Instruction guide for optional spacer.
Содержание TG308
