Santerno Sinus M, Руководство пользователя

Страница: 56 / 219

7-6
LED
display
Parameter
name
Min/Max
range
Description
Factory
defaults
Adj.
during
run
F30 [V/F pattern] 0 ~ 2 0 {Linear} 0 X
1 {Square}
2 {User V/F}
F31
1)
[User V/F
frequency 1]
0 ~ 400
[Hz]
It is used only when V/F pattern is set to
2(User V/F).
It cannot be set above F21 – [Max
frequency].
The value of voltage is set in percent of
H70 – [Motor rated voltage].
The values of the lower-numbered
parameters cannot be set above those
of higher-numbered.
15.00 X
F32
1)
[User V/F
voltage 1]
0 ~ 100
[%]
25 X
F33
1)
[User V/F
frequency 2]
0 ~ 400
[Hz]
30.00 X
F34
1)
[User V/F
voltage 2]
0 ~ 100
[%]
50 X
F35
1)
[User V/F
frequency 3]
0 ~ 400
[Hz]
45.00 X
F36
1)
[User V/F
voltage 3]
0 ~ 100
[%]
75 X
F37
1)
[User V/F
frequency 4]
0 ~ 400
[Hz]
60.00 X
F38
1)
[User V/F
voltage 4]
0 ~ 100
[%]
100 X
F39 [Output voltage
adjustment]
40 ~ 110
[%]
This parameter adjusts the amount of
output voltage.
The set value is the percentage of input
voltage.
100 X
F40 [Energy-saving
level]
0 ~ 30
[%]
This parameter decreases output
voltage according to load status.
0 0
F50 [Electronic
thermal
select]
0 ~ 1 This parameter is activated when the
motor is overheated (time-inverse).
1 0
F51
2)
[Electronic
thermal level
for 1 minute]
50 ~ 200
[%]
This parameter sets max current
capable of flowing to the motor
continuously for 1 minute.
The set value is the percentage of H33
– [Motor rated current].
It cannot be set below F52 –[Electronic
thermal level for continuous].
150 0
F52
2)
[Electronic
thermal level
for continuous]
This parameter sets the max motor
current for continuous operation.
It cannot be set higher than F51 –
[Electronic thermal level for 1 minute].
100 0
1)
: Set F30 to 2(User V/F) to display this parameter.
2)
: Set F50 to 1 to display this parameter.