Santerno Sinus M, Руководство пользователя, Страница: 88 / 219

9-10

Rotating direction selection via –10 ~ +10[V] input of V1 terminal
Group Code Parameter Name Setting Range Initial Unit
Drive group frq [Frequency setting] 2 0 ~ 7 0
drv [Drive mode] - 0 ~ 3 1

Set
frq
to 2.

Inverter is operating as the table below regardless of Drive mode setting.
FWD RUN Command REV RUN Command
0 ~ +10 [V] FWD RUN REV RUN
–10 ~ 0 [V] REV RUN FWD RUN

Motor runs in Forward direction when input voltage to V1-CM is 0~10[V] and FWD RUN command is
active. When input voltage polarity is reversed to –10~0[V] during FWD RUN, motor decelerates to stop
and runs in reverse direction.

When input voltage to V1-CM is 0~10[V] and REV RUN command is active, motor runs in Reverse
direction and if –10~0[V] is entered, the motor rotating direction is reverse.

FX/RX Run Disable
Group Code Parameter Name Setting Range Initial Unit
Drive group drC
[Direction of motor
rotation select]
- F, r F
Function group 1 F1
[Forward/Reverse run
disable]
- 0 ~ 2 0

Select the direction of motor rotation.

0: Forward and Reverse run enable

1: Forward run disable

2: Reverse run disable