SAEVO EVUS 8, Руководство пользователя

Страница: 125 / 150

13 Probes and Biopsy
Basic User Manual 115
b. Apply an appropriate amount of coupling gel to the inside of the sheath and onto the face of the probe.
c. Hold the probe and unroll the sheath onto the probe.
d. Pull the probe sheath tightly over the face of the probe to remove wrinkles.
e. Secure the sheath to the probe with the adhesive tapes or elastic bands.
3. Orient the probe.
Check the probe orientation mark before the scan.
4. Perform a scan.
■ Intraoperative probe usages
1. Wear sterile medical gloves.
2. Ensure the bending section of intraoperative probe is free and can bend freely.
a. Rotate two angulation knobs to adjust the probe distal end to the desired angle.
b. Lock the angulation knobs if they are adjusted properly.
3. Perform a scan.
13�1�3 Cleaning the Probe
!
● To avoid electrical shock, disconnect the probe from the system before cleaning.
●
To avoid potential disease transmission, you should wear sterile medical gloves and protective goggles while
cleaning.
● Do not use the cleaner that contains sodium sulfate and/or sodium hypochlorite to clean the probe. Otherwise,
the probe may be damaged.
● To avoid probe damages, do not bump the probe on hard surfaces.
● Use only the cleaner recommended by the manufacturer to clean the probe. Otherwise, the probe may be
damaged.
You should clean the probe before and after each use. Probe cleaning is an essential step of the disinfection and
sterilization.
Perform the following steps to clean the probe.
1. Remove the coupling gel from the probe surface after exam.