4. Description of the RPCM Device
Pressing the top button for a long time for about 20 seconds resets the RPCM
to the factory de-
fault settings
. After that, the password of the user
rpcmadmin
will be reset to the standard —
rpcmpassword
. If for some reason there is no user with such a name, it will be created again with
the standard password
rpcmpassword
.
4.1.3.3. Description of the Control Mode
This mode is intended for operational control.
All messages in the Control Mode (Control Mode) are displayed yellow.
The entrance to the Control Mode is made by pressing while holding the bottom key. Immediately
after logging in, an inscription in the form of a running line will appear on the indicator panel:
"
Control Mode! Be Careful!
"
Next, you are prompted to return to the "
Return To View Mode
" view.
A step-by-step transition between the available functions occurs by a single press of the bottom
button. A single press of the top button performs a step-by-step transition in the reverse order.
Pressing and holding the lower button causes a state change for the proposed function. For ex-
ample, pressing and holding the bottom button while the function is active
Outlet 1 Switch OFF
performs administrative shutdown of the 1st pin. Accordingly, after its activation, the function of
administrative activation —
Outlet 1 Switch ON
becomes available.
The list of available functions and corresponding informational messages is presented in Table
4.1.2.
ATTENTION!
Do not press the control buttons of the module control unnecessarily! Erroneous or
untimely use of controls can lead to unpredictable actions, such as disabling the client device and
creating an emergency. Please, in case of unusual situations, contact RCNTEC support service.
4.1.3.4. Objects and Functions of Control Mode
When working in Control Mode, the concepts of "object" and "function" are distinguished.
An object is something that needs to be performed. This can be a separate output, input, ATS for
switching outputs in the models RPCM DC ATS 76A also RPCM as a device.
Individual objects: inputs and outputs are displayed on the panel with the corresponding digit.
When you select this object for manipulation, its indicator starts flashing.
Step-by-step transition between objects is performed using a single press of the bottom or top
button.
The available manipulations with these levels are displayed immediately upon entering the Con-
trol Mode after a suggestion to return to the view mode -
Return To View Mode
.
Operations with inputs and outputs are available after a step by step transition to the next level.
33
