4. Description of the RPCM Device
4.1.3. Front panel device control
4.1.3.1. Basic Principles
An indicator is used to obtain information about the status of devices.
When controlling RPCM through a physical interface (upper and lower buttons), the following ac-
tions are used:
quick press — pressing and releasing the button for 0.5 - 1 seconds, waiting for the result af-
ter releasing;
press and hold — press and hold the button for more than 5 seconds to get the effect.
There are two interface modes:
View mode;
Control Mode.
RPCM start in View Mode.
4.1.3.2. View Mode
In this mode, the original information is displayed.
Alerts in view mode (View Mode) are displayed in green, except for the message specified by the
user — it is displayed in red.
The list of messages View Mode is presented in table 4.1.1.
Switching between messages in the view mode occurs by pressing the top or bottom buttons.
The bottom button switches the messages on the screen in order from top to bottom according to
Table 4.1.
The top button toggles the values in reverse order.
In order to avoid accidental skipping of the desired item, the upper or lower button must be
pressed, released, wait for the result for 5 seconds.
Switching occurs in a circle (cyclically). For example, with successive presses of 5 seconds for the
bottom button, "
Voltage
", then "
Current on input
", then "
Power
", "
IP address
", "
MAC address
", "
Se-
rial name
", "
Serial number
", "
User message
", then again "
Voltage
", "
Current at input
" and so on.
In View Mode, special functions are also available:
reset to factory settings;
reboot control module —
High Level Controller (HLC)
, which is running Software.
32
