4. Description of the RPCM Device
The bottom button switches the messages on the screen in order from top to bottom according to
Table 4.1.1.
The top button toggles the values in reverse order.
At system starts, the information display sequence is follows:
Initially, the message "
RPCM has started
" appears in the module display for 5 seconds;
5 seconds after startup, default message is displayed and has the appearance of a running
line going left-to-right;
The following data is displayed when the button is pressed.
Then, when the button is pressed, the following are alternately displayed:
current;
power;
IP address;
MAC address;
serial number;
serial name;
user message.
To view in the reverse order, you need to press the top button. The values will be displayed in re-
verse order except for the message "
RPCM has started
".
It is possible to reset the system to factory settings.
To reset to factory settings, you must
press the top button on the device and hold for 20 seconds.
The
rpcmadmin
user password will be reseted to the default password. If a user with this name is
missing for some reason, it will be created again with the default
rpcmpassword
password.
ATTENTION!
Do not attempt to use non-standard sequences to control the module unless neces-
sary! Incorrect or untimely use of controls can lead to failure and emergency situations. Please, con-
tact RCNTEC support, if you have any non-standard scenarios.
The left side of the display panel is used to represent the status of the input and outlet channels:
inlet indicators
1
and
2
for models RPCM DC ATS 76A or single inlet indicator for models
RPCM DC 232A;
indicators for the ten outlets
0
—
9
.
29