Rauch AXEO 16.1, Инструкция по эксплуатации

Страница: 100 / 136

Spreading work 8
92
8.6 Spreading of salt
When spreading dry salt, please observe the following:

Using agitator RWK AX 220 . Refer to 11.6.4: RWK AX 220, page 115 .

The maximum PTO speed of 540 rpm and/or a spreading disc speed of 230 rpm
is to be observed.

Before each transportation drive, the drive is to be disengaged.

With a closed metering slide, even for short distances, switch off the machine
drive.

Open the metering slide until unobstructed discharge of dry salt at the agitator.

Slowly couple the PTO shaft at a low motor speed of the tractor in order to
prevent damage to the agitator drive.

Switch off the agitator when the hopper is empty.

Please observe the information on assembly and disassembly of the
RWK AX 220 agitator in the respective assembly manual. See also chapter
9.5.1: Dismounting the agitator, page 101 .

Due to the hygroscopic effect of salt, only use the machine with a hopper cover.

Avoid a longer storage of salt in the hopper.
n
WARNING
Risk of injury caused by spreading material
Ejected spreading material may lead to injuries.
 Ensure that nobody is present in the hazard zone.
NOTICE
Depending on the quality and under ideal conditions, agitator RWK AX 140 may
also be applied for spreading of dry salt.
NOTICE
Cleaning after each use of the machine prevents deposits at the bottom of the
hopper. You can thus reduce the wear of the agitator and increase the opera-
tional reliability of your machine.
NOTICE
If the performance of the agitator is insufficient, lock the central finger with a M6
screw.