Rauch AXEO 16.1, Инструкция по эксплуатации

Страница: 102 / 136

Spreading work 8
94
8.8 Spreading grit-salt mixtures
When spreading grit-salt mixtures, please observe the following:

Using agitator RWK AX 240 . Refer to 11.6.5: RWK AX 240, page 116 .

The maximum PTO speed of 450 rpm and/or a spreading disc speed of 200 rpm
is to be observed.

Before each transportation drive, the drive is to be disengaged.

With a closed metering slide, even for short distances, switch off the machine
drive.

Open the metering slide until unobstructed discharge of grit-salt mixture at the
agitator.

Slowly couple the PTO shaft at a low motor speed of the tractor in order to
prevent damage to the agitator drive.

Switch off the agitator when the hopper is empty.

Please observe the information on assembly and disassembly of the
RWK AX 240 agitator in the respective assembly manual. See also chapter
9.5.1: Dismounting the agitator, page 101 .
With temperatures below 0 °C, moist spreading material may freeze in the hopper
and damage the agitator when the PTO shaft is switched on.

Ensure that the spreading material cannot freeze in the hopper.

Do not leave filled machines outside over night.

Keep spreading materials dry.
n
WARNING
Risk of injury caused by spreading material
Ejected spreading material may lead to injuries.
 Ensure that nobody is present in the hazard zone.
NOTICE
Cleaning after each use of the machine prevents deposits at the bottom of the
hopper. You can thus reduce the wear of the agitator and increase the opera-
tional reliability of your machine.
NOTICE
When spreading grit-salt mixtures, bridging may occur above the agitator.

In this case, reduce the salt content and use dry spreading material.