Rauch AXEO 16.1, Инструкция по эксплуатации

Страница: 95 / 136

Spreading work
87
8
8 Spreading work
8.1 General information
The modern technology and design of the machine and exhaustive, continuous
testing in the factory's spreading material test facilities ensure that you will have
a perfect spreading pattern.
Our machines are manufactured with utmost diligence. However, deviations in
the application rate or possible faults cannot be excluded, even when complying
with the intended use.
The reasons for this may be:

Changes in the physical characteristics of the spreading material due to the
running agitator during transportation (e.g. varying fractional composition,
varying density, grain form and surface, humidity).

Clumping and moist spreading material.

Wind drift: In the case of excessive wind speed, cancel the spreading work.

Blockages or bridge formation, e. g. due to foreign bodies, bag residue or
moist spreading material ...

Uneven ground.

Abrasion of wear parts, e.g. agitator, spreading vanes, outlet.

Damage from external causes.

Inadequate cleaning and care to prevent corrosion.

Incorrect drive speeds and forward speeds.

Calibration test has not been carried out or calibration test has been carried
out with incorrect values (e.g. incorrect PTO speed).

Incorrect machine adjustments.
Pay close attention to the machine settings. Even a minor deviation from the cor-
rect setting may significantly affect the spreading pattern. Therefore, before each
operation and during operation, check the correct functioning of your machine
and ensure that the application accuracy is sufficient. Carry out a calibration test.
NOTICE
Cleaning after each use of the machine prevents deposits at the bottom of the
hopper. You can thus reduce the wear of the agitator and increase the opera-
tional reliability of your machine.