Rauch AXEO 16.1, Инструкция по эксплуатации

Страница: 70 / 136

Machine settings 7
62
3. Reset the spreading vanes against the rotary direction of the spreading disc.
 With this setting, the spreading material is ejected earlier.
4. Screw on the spreading vane (tightening torque: approx. 18 Nm). Always
use new self-locking nuts when screwing on the vane.
 The spreading density on the right-hand side viewed in the direction of
travel is increased.
7.8.2 Increasing the spreading density on the left-hand side in the direction of travel
1. Observe the rotational direction of the spreading discs. Refer to figure 7.10 .
2. Disassemble the screws of the spreading vanes including the corresponding
nuts and washers.
Figure 7.12: Spreading density on the left in the direction of travel
White arrow: Rotational direction of the spreading disc
Grey arrow: Adjustment of the spreading vanes in the rotational direction of the
spreader disc
3. Set the spreading vanes in the rotary direction of the spreading disc.
 Using this setting, the spreading material will be ejected later .
4. Screw on the spreading vane (tightening torque: approx. 18 Nm). Always
use new self-locking nuts when screwing on the vane.
 The spreading density on the left-hand side viewed in the direction of
travel is increased.