Rauch AXEO 16.1, Инструкция по эксплуатации

Страница: 51 / 136

Commissioning
43
6
6.5 Connecting the hydraulic drive (Version H-100/200, Q-100/200, C-100/200,
Q-100/200-HC)
Depending on the model, the AXEO single-disc spreader may be equipped with
a hydraulic motor as drive for the spreading disc and the agitator.
A single-acting control valve and a free return flow are needed on the tractor. In
addition, a non-return valve is fitted in the return line.
The hydraulic drive is connected to the tractor via 2 hydraulic hoses.
Adjusting the hydraulic drive (H-100/200, Q-100/200, C-100/200)
The single-disc spreader is driven by a hydraulic motor with a displacement of
100 cm³ or 200 cm³.

Adjust the agitator speed to your spreading material as specified in the fertil-
iser chart.

Set the agitator speed at the hand wheel of the flow control valve.
Figure 6.8: Flow control valve
NOTICE

Connect the connector with the red protection cap to the pressure line.

Connect the connector with the blue protection cap to the return line.

Uncoupled hydraulic hoses must not get into contact with the ground.

Always put a dust cap on the uncoupled hydraulic hoses.

Secure the uncoupled hydraulic hoses only at the bracket provided for hoses
and cables. Refer to
figure 3.5 .
NOTICE
Spreading disc and agitator drive for machines with HydroControl (model Q-
100/200-HC) is realised automatically at the QUANTRON-K2 control unit.
The HydroControl function is described in a separate operator's manual for the
QUANTRON-K2 control unit.