Pulsar ULTRA 5, Инструкция по эксплуатации

Страница: 186 / 258

Page 178
Data Log Parameters
The data log parameters contain the following information.
Totaliser Audits
When Ultra Wizard = 2 Pump/Differential
and
Pump Volume Enabled P205 = 1
or
When Ultra Wizard = 3
P460 to P479 Total Audits
Parameters P460 - P479 show the date and pumped volume total for the last
ten days , the first on the list are the most recent and last ones are the oldest.
When all ten total audits are full the oldest is pushed out and all totals
increment through to allow the new days total to be registered in the first
day’s total audit parameter allocation.
Important Information
In order to ensure the accuracy of pumped Volume, during a 24-hour period,
the
Time P932 must be set correctly. And if required, enable Daylight
Saving for the appropriate time difference P970 – P979 .
P480 Clear Logs
This parameter enables all of the Total Audits (P460 – P479) to be cleared
to factory default values.
Temperature
The following parameters give information on temperature conditions seen
by the
Temperature source ( P852 ) in ºC. All of these parameters are read
only and cannot be changed, though if P852 is changed they will be reset.
P580 Minimum Temperature
This parameter displays the minimum temperature recorded.
P581 Minimum Temperature Date
This parameter displays the date when the minimum temperature was
recorded.