Pulsar ULTRA 5, Инструкция по эксплуатации

Страница: 195 / 258

Page
187
Tables
P696 Reset Breakpoints
This parameter allows the resetting, to the default value, of all previously set
breakpoints (P610-673), without having to access them individually. When
it is necessary to reset or amend particular breakpoints this can be achieved
by directly accessing the desired parameter (P610-673) and changing as
required.
P697Number of Breakpoints Set
This parameter allows you to review the number of breakpoints that have
been set, without the need to access each individual one in turn, this is a
“Read Only” parameter and no values can be entered.
Pump Efficiency
When Ultra Wizard = 2 Pump/Differential
Set Up
P187 Pump Eff.?
This parameter determines whether pump efficiency is enabled or disabled.
Option Description
0 = Off (Default) Pump efficiency is disabled
1 = On Pump efficiency is enabled
P188 Calib. Delay
This parameter is used to set a delay, after all pumps have stopped, to allow
for any turbulence of the material surface to settle prior to monitoring the
level in the vessel and determining the inflow before the next pump cycle
commences. The delay time is entered in seconds.
Default = 45 seconds .
Important Information
When setting the time period for the Calibration Delay (P188) it is
important that it does not exceed the time from when all pumps switch Off
to the first pump Start during normal operation as it will prevent
determining the Inflow and any subsequent calculation of Efficiency .