Pulsar ULTRA 5, Инструкция по эксплуатации

Страница: 154 / 258

Page 146
P103 Input 2 (Optional)
The 4-20 mA input is available as an option (Consult Pulsar for details of
availability), and can be used to replace the transducer for applications
where an ultrasonic transducer cannot be used.
Use this parameter to set the second input device when using in Average or
Differential Mode, and
P101 Transducer = 1 (Optional Auxiliary Input).
Option Description
0= None (Default) Second Transducer input not required.
1 = dB3 Transducer is a dB3. Range 0.125 to 3.00 metres
2 = dB6 Transducer is a dB6. Range 0.3 to 6.00 metres
3= dB10 Transducer is a dB10. Range 0.3 to 10.00 metres
4= dB15 Transducer is a dB15. Range 0.5 to 15.00 metres
5= dB25 Transducer is a dB25. Range 0.6 to 25.00 metres
6 = dB40 Transducer is a dB40. Range 1.2 to 40.00 metres
7 = dBS6 Transducer is a dBS6. Range 0.2 to 6.00 metres
8 = dBMach3 Transducer is a dBMach3 Range 0.0 to 2.425 mtrs.
Dimensions
P104 Measurement Units
This parameter sets the units you want to use for programming and display
Option Description
1 = metres (Default) All units of measure are
METRES
2 = cm All units of measure are
CENTIMETRES
3 = mm All units of measure are
MILLIMETRES
4 = feet All units of measure are
FEET
5 = inches All units of measure are
INCHES
P105 Empty Level
This parameter is to be set to the maximum distance from the face of the
transducer to the empty point , in P104 Measurement Units . Note this
value affects span as well, (see important information below), so should be
set before span.
Important Information
When using the dB Mach 3 the empty distance is measured from the end
of the horn to the empty point in P104 Measurement Units .