Planmeca Chairside PlanCAD Easy, Руководство пользователя

Страница: 141 / 180

28 MILLING UNIT
User’s manual Planmeca Chairside CAD/CAM solution 135
28.3 Lid lights
The lid lights change colour based on the status of the
mill.
The colour coding is explained in the table below.
28.4 Relocating the milling unit
WARNING
The milling unit weighs approximately 100 kg (220
lbs.). Always follow these guidelines when relocating
the mill.
Be certain to drain the milling unit’s fluid reservoir before
moving the unit.
The milling unit is designed to operate on a level and
stable surface in an environment free from excessive
moisture or dust. The mill should be located away from
the patient access area. When choosing a location for the
mill, adhere to all clearance requirements stated in
System Specifications.
1. Ensure no milling operations are in progress.
2. Open the front access panel and remove the fluid
reservoir.
3. Empty the fluid reservoir according to your approved
material disposal protocols.
4. Turn OFF the mill.
5. Disconnect all power and data connections.
6. Lift the mill onto a cart that is capable of supporting the
weight of the mill and its accessories. It it recommended
to use a suitable cart rather than moving the mill by hand.
Lifting and carrying should be kept to a minimum.
NOTE
The mill weighs approximately 100 kg (220 lbs). Lifting the
mill requires at least two people.
Lid colour Description
Blue Mill is initializing
Green (solid) Mill is idle or is milling. It can accept instructions (select restorations,
cancel milling, replace tools, etc.)
Green (flashing) Milling complete. The restoration has completed milling and the lid is
open.
White Lid is open.
Yellow Warning displayed.
Red (solid) The mill is in the “diagnostic” mode. Re-initialize the mill to return to idle.
Red (flashing) The mill has faulted. Warning screen: Re-initialize to clear the fault or
enter the diagnostic state to attempt to diagnose the problem.