P
ERFORMING
W
ELDING
O
PERATION
W
ELDING
O
PERATION
C
HAPTER
5
52
•
Other welding methods
1.
Check that the welding conditions are correctly set and carry out the following operation to start the welding.
●
For TIG welding: Contact the torch electrode with the base metal, and then raise the torch.
●
For DC STICK welding: Contact the electrode with the base metal, and then raise the electrode.
B
During the welding, the “Welding time” and “Heat input” are displayed on the LCD panel both in a real time
basis.
B
During the welding, the LED for the welding sequence being carried out flashes.
2.
Welding operation is completed by the following operation.
●
For TIG welding: Complete the operation by separating the torch electrode from the base metal.
●
For DC STICK welding: Complete the operation by separating the electrode from the base metal.
B
The LED for the welding sequence changes to the light-up mode.
T I P S
If the TIG valve controller (optional accessory) is used, the start and completion of the
welding operation can be controlled by the torch switch operation. (
6.7.2.48
-
F81: TIG
Mode torch switch setting)
2SHUDWLRQGXULQJZHOGLQJ
This section explains the operation requiring adjustment of welding current/voltage during the welding. The welding
current/voltage can be adjusted during each sequence such as welding under initial condition, welding condition, or
crater condition.
T I P S
When the analog remote control (optional) is connected, the welding current/voltage under
the welding condition cannot be adjusted on the operation panel. Adjust the welding
current/voltage for the welding condition at the analog remote control.
If the TIG valve controller will not be used in TIG welding, be sure to shut off the gas after
completion of welding.
There is a risk of suffocating if closing the gas is forgotten in case opening/closing of
the gas is done manually.
CAUTION
After five seconds have passed after switching the welding method to “DC TIG” or “DC
STICK”, the safety voltage (approx. 15 V) is automatically provided. Before switching the
operation, make sure that the torch electrode (welding electrode) is not in contact with
the base metal.
Содержание Welbee M350 II
