OTC Welbee M350 II, Руководство пользователя

Страница: 73 / 148

71
Chapter 6 W
elding Condition
S
ETTING
W
ELDING
C
ONDITIONS
W
ELDING
C
ONDITION
C
HAPTER
6
:HOGLQJSDUDPHWHUVHWWLQJ
This section explains how to set the welding parameters (gas discharge time, welding current/voltage) according to the
welding sequence.
1.
Set the gas discharge time.
●
Press the DISPLAY CHANGE key, and select the LED of "PRE FLOW" (or "POST FLOW").
● Turn the parameter adjustment knob to set the gas discharge time.
⇒ The set parameter is displayed on the left digital meter.
2.
Set the welding current.
● Press the DISPLAY CHANGE key, and select the LED of "MAIN CONDITION" (or "INITIAL CONDITION" or
"CRATER-FILL CONDITION").
● When the LED above the 7-segment display (for current adjustment) is off, press the parameter adjustment knob
to light up the LED.
(The welding current can also be set based on the wire feed speed. In this case, refer to "6.7.2.19
-
F24: Wire feeding
speed setting")
● Turn the parameter adjustment knob to set the welding current.
⇒ The set parameter is displayed on the left digital meter.
T I P S
• In the setting of welding current, the wire feed speed automatically set according to the
welding current can be checked. Press the UNIT CHANGE key to light off the LED ("IPM":
On, "A": Off), and the value displayed on the left digital meter switches to the display of
wire feed speed. Pressing the UNIT CHANGE key again to light on ("IPM": Off) returns the
display to the one of welding current.
UNIT CHANGE key
DISPLAY CHANGE key
POST FLOW
LED
CRATER-FILL CONDITION
LED
MAIN CONDITION
LED
PRE FLOW
LED
INITIAL CONDITION
LED
Parameter adjustment knob Screen operation knob