73
Chapter 6
W
elding Condition
S
ETTING
W
ELDING
C
ONDITIONS
W
ELDING
C
ONDITION
C
HAPTER
6
&UDWHU2))
Select "CRATER OFF" by the CRATER-FILL menu.
•
In synchronous to the ON/OFF operation of the torch switch, the welding starts/stops.
&UDWHU21QRLQLWLDOFRQGLWLRQ
Select "CRATER-FILL ON" by the CRATER-FILL menu and select "INITIAL CONDITION OFF" by the INITIAL
CONDITION menu.
•
Carry out twice the ON/OFF operation of the torch switch and carry out the welding operation. In the second ON
operation, the welding sequence is carried out by the crater current.
•
Even if the torch switch is switched off during welding, the signal will be self-hold. (The torch switch should remain
depressed and held during the CRATER phrases.)
Torch switch
Gas flow
Output voltage
Wire feeding speed
Welding current
Main welding
Anti-stick time
ON
OFF
Pre-flow
Post-flow
No-load voltage
Slow-down speed
Welding current
ON
OFF
Main welding
Anti-stick time
OFF
Crater-fil
䡈
OFF
Crater-fill current
Torch switch
Gas flow
Output voltage
Wire feeding speed
Welding current
Pre-flow
Post-flow
No-load voltage
Slow-down speed
Welding current
ON
OFF
ON
OFF
ON
ON
Содержание Welbee M350 II
