Olivetti d-Color MF 4003, Руководство по обслуживанию

Страница: 375 / 688

d-Color MF4003/MF3303
J BILLING SETTING/ENHANCED SECURITY/DEBUG SETTINGS > 2. ENHANCED
SECURITY
J-21
Switch No. Function
32 Choice of changing AT1VC condition
33 Choice 1 of extending PU life
34 Choice of extending PU life
35 Choice of improving fusibility strength
36 Choice of increasing stabilization frequency
37 Choice of silent mode
38 Not used
39 Choice of disabling engine log via CTL
40 Not used
41 Not used
42 Choice of increasing registration frequency
43 Choice of HH memory upper limit voltage
44 Not used
45 Not used
46 Choice of UFP behavior mode
47 Not used
48 Replacement timing Intelligent Control of Transfer Roller Unit
49 Not used
50 Replacement timing Intelligent Control of Imaging unit (K)
51 Not used
52 Not used
53 Not used
54 Not used
55 Choice of following-up properties in early morning
56 Choice of disabling duplex tacking PPM
2.10.1 Details of Each Function
(1) New Release Disable mode
• To enable a unit that is used temporarily for troubleshooting to be used again as a new unit in another machine, the New Release
Disable mode is provided.
• Applicable units are the following units that have the new unit detection feature.
• Drum unit, developing unit
• When the New Release Disable mode is set, the parameter of the unit before replacement is used without making automatic adjusting
control with the TCR sensor and new image stabilization control.
Switch No. 3 Contents Default
OFF Disables New Release Disable mode.
○
ON Enables New Release Disable mode.
<Procedure>
1. Open the front door.
2. Call the [Service Mode] -> [Enhanced Security] to the screen.
3. Set [Engine FW DipSW] -> [3] to ON.
4. Close the front door.
By closing the front door, the New Release Disable mode takes effect.
Notes when using the New Release Disable mode
<Before starting the mode>
• Output the list in [Service Mode] -> [List Output] to check the information on the wear-out rate of each unit and keep the Dmax density
adjustment value. Replace units that have reached their part replacement time or that are near life with new ones, and perform New
Release.
• If the toner is empty, start this mode when the toner empty status is resolved by replacing the toner cartridge with a new one or charging
the toner.
<During the New Release Disable mode>
• The New Release Disable mode is subject to the condition that the New Release Disable mode should not be used for a long period, i.e.
duration of printing only several tens of sheets.
• Units used in the New Release Disable mode for a long time cannot be guaranteed as new ones.
• In the New Release Disable mode, the drum unit/K life counter is not reset and it continues to count in a normal manner. If the counter
reading becomes close to the value for the replacement time, the replacement time can be reached in the New Release Disable mode.
• If the drum unit/K counter should reach the value for the replacement time while temporarily using a new drum unit/K in the New
Release Disable mode, turn OFF the New Release Disable mode, open and close the front door (or turn the main power switch OFF
and ON), and perform New Release in a normal manner. In this case, the previous drum unit/K, which has been temporarily
removed, cannot be used again.
• After activating the New Release Disable mode in [Engine FW DipSW], do not turn OFF and ON the main power switch or do not let the
machine go into the sleep mode until the work in the New Release mode is completed.
Y119930-3 Service Manual