Olivetti d-Color MF 4003, Руководство по обслуживанию

Страница: 273 / 688

I SERVICE MODE > 10. System 2
I-57
d-Color MF4003/MF3303
NOTE
▪ To enable the maintenance mode, set [Administrator] -> [Security] -> [Security Details] -> [Maintenance Mode Access] -> to
[Allow].
Setting item Contents Setting value Default setting
Maintenance Mode Set whether to enable or disable the Maintenance Mode. Invalid
○
Effective
Display language Select the language to be displayed in the Maintenance Mode. When
[Not Set] is selected, the displayed language is that valid before the
machine enter the Maintenance Mode. Not Set
○
Display
language
Job History Clear Upon Job
Completion Set whether to erase the past job history and the job history during the
Maintenance Mode. Set
○
Unset
<Exiting the Maintenance Mode>
• To exit the Maintenance Mode, select [Service Mode] -> [System 2] -> [Maintenance Mode] and touch [Invalid], or touch the arrow key on
the control panel and select [Yes] from the confirmation screen.
10.26 Smart Fusing Control
• Specifies whether or not to apply low power fusing control.
Setting value Contents Default setting
Permit Applies low power fusing control by lowering the target temperature as much as possible in response
to the single sheet data. In this way, the power consumption (TEC value) is controlled.
○
Prohibit Controls the adjustment of the specified fusing temperature.
10.27 Cleaning Unit Setting
• Use this feature upon the optional clean unit set-up.
Setting value Default setting
Installed
Not Installed
○
10.28 Fuser roll deform
• Rotates the fusing belt to prevent the same fusing belt surface from being left alone for long periods of time in order to prevent deformation.
• Prevents unevenness in gloss caused by fusing belt deformation.
Setting value Detail Default setting
OFF -
○
Mode 1 * • Rotates the fusing roller for a certain distance when the machine has been in standby mode for over
6 hours.
• Rotates the fusing roller for a certain distance when the machine has been in energy save mode for
over 13 days.
• (Energy save mode in this case does not include sub power OFF mode and ErP Auto Power OFF
mode.)
Mode 2 * • Rotates the fusing roller for a certain distance when the machine has been in standby mode for over
6 hours.
• Rotates the fusing roller for a certain distance when the machine has been in energy save mode for
over 13 days.
• (Energy save mode in this case does not include sub power OFF mode and ErP Auto Power OFF
mode.)
• Rotates the belt for 30 seconds while warming the fusing unit up to a certain temperature during the
warmup process or when starting to print in order to prevent belt deformation.
*: Perform the following steps when selecting this setting to an option other than [OFF].
• When setting the [Weekly Timer ON/OFF Settings] found under [Administrator Settings] -> [System Settings] -> [Weekly Timer Settings] to
[ON], select the energy save mode when the weekly timer is turned off to [Sleep].
• Select [Power Save] in the [Power Key Setting] found under [Administrator Settings] -> [System Settings] -> [Power Supply/Power Save
Settings].
• Do not turn off the main power switch.
• Do not turn off the sub power switch. (Do not long-press the power key.)
10.29 Auth. Function Enable
Activation
• Use to activate the advanced function after certification.
<Procedure of entering function codes manually>
1. Touch [Activation].
2. Confirm that [Function Code] is selected, and the press the [Function Code].
3. Enter the function code and touch [END].
4. Confirm the instructions on-screen and touch [Apply].
<Procedure of importing function codes via a USB device>
Y119930-3 Service Manual