Nortel BCM 3.7, Руководство пользователя

Страница: 266 / 1004

266 Assigning Trunk/line data
N0008589 3.3
Prime set DN:
None
Assign a telephone to provide backup answering for calls on the line. For an Auto
Answer line, calls are redirected if the received number is invalid or the target line is
busy, and if the
If busy parameter is set To prime .
Each line can be assigned only one prime telephone.
Distinct rings
in use read-only This field shows the Distinct Ring Patterns that have already been assigned to at
least one line.
Distinct ring None
Pattern 2
Pattern 3
Pattern 4 Choose the distinctive ring pattern that you want to assign to the line. This allows
you to provide selective service to calls with differing answer priorities.
When more than one line with the distinct ring settings rings at a telephone, the line
with the highest priority will ring first.
• Pattern 4 has the highest ring priority
• Pattern 3 has second highest ring priority
• Pattern 2 has third highest ring priority
• None has the lowest ring priority.
By default, all telephones and lines are set to None
Warning:
If you assign a distinctive ring pattern to a line, and that distinctive ring pattern has
already been assigned to a telephone, all telephones with that ring pattern will be
reset to pattern 1.
If you assign a distinctive ring pattern to a telephone, and that distinctive ring
pattern has already been assigned to a line, all lines with that ring pattern will be
reset to None.
Auto privacy Y or N This setting has no effect on VoIP lines.
Use auxiliary
ringer Y or N Turn the auxiliary ringer on or off for all telephones using this line.
When programmed on a line, the auxiliary ringer will ring every time a call is
received.
Note: When programmed only on a telephone, no ring occurs for a transferred call.
An auxiliary ringer can also be programmed in Services to ring for a line placed into
a scheduled Ringing service. Refer to
“Configuring ringing service” on page 496
Full autohold Y or N Enables or disables Full autohold.
When enabled, if a caller selects an idle line but does not dial any digits, that line is
automatically placed on hold if you then select another line.
The default setting should be changed only if Full autohold is required for a specific
application.
WARNING: Enable modules
If you disabled any trunk media bay modules prior to performing programming, enable them now to
ensure your system will function properly.
Table 40 VoIP line data fields (Continued)
Attribute Value Description