Nidek Medical ME-1000, Руководство по обслуживанию

Страница: 110 / 134

7 - 24
LLE11ARDA001A/E
7.11.2 Adjusting the Hole Diameter
1. Read the Drill Adjustment Pattern (Diameter).
(See 7.2.5.)
2. Put the lens into the processing chamber and
grind it.
3. Check the drilled hole with a straight pin
(M6) of
φφφφφ
2.0. Push the pin to the hole and
select the hole that the pins can pass through.
1) :
φ
2.00, inclination 0.0 (perforated)
2) :
φ
2.06, inclination 0.0 (perforated)
3) :
φ
2.12, inclination 0.0 (perforated)
* The diameter of the holes to vary in +0.02
increments from 0.00 to +0.12.
4. Follow the procedures below to enter the
adjustment parameter value suited to the
hole.
1) Establish the Parameter Setting mode.
(See 7.1.2.)
2) Press Adjustment.
3) Press Groove & Drilling.
4) Change the following parameter setting.
a. Hole Diameter
* Add +0.06 when the hole is proper. Add
+0.12 when the hole is proper.
4QWIJ5K\G
(KPKUJ5K\G
2QNKUJ5K\G
2QNKUJ&KHH
#:+5
5CHGV[$GXGN
)TQQXG&TKNN
Adjustment
)TQQXG2QUKVKQP
)TQQXG&GRVJ
%WVVGT<GTQ2QKPV
*QNG&KCOGVGT
*QNG5NQV4GHGTGPEG
&TKNN<GTQ2QKPV<
&TKNN*QNG8GTVKECN2QUKVKQP;
(TQPV5WTHCEG1HHUGV
*QNFG&GRVJ:
)TQQXG2QUKVKQP
)TQQXG&GRVJ
%WVVGT<GTQ2QKPV
*QNG&KCOGVGT
*QNG5NQV4GHGTGPEG
&TKNN<GTQ2QKPV<
&TKNN*QNG8GTVKECN2QUKVKQP;
(TQPV5WTHCEG1HHUGV
*QNFG&GRVJ:
BACK