535-PROF User's Manual
Chapter 5
29
Controller Set Up
PARAMETERS
Within each menu are
parameters
for particular control functions. Select val-
ues for each parameter depending on the specific application. Use the
MENU
key to access parameters for a particular menu; the parameter name will re-
place the menu name in the 2nd display, and the parameter value will show in
the 3rd display.
This chapter outlines
all
the available parameters for the 535-PROF. Some pa-
rameters are
independent
of any special configuration, and others are
depen-
dent
on the individual configuration. This manual displays these two types of
parameters differently; refer to
Figure 5.3. A special feature of the 535-PROF,
called
Smart Menus
, determines the correct parameters to display for the spe-
cific configuration, so not all the listed parameters will appear.
CONFIGURATION AND OPERATION
Figure 5.3 shows the relationships among the different modes of the 535-PROF
and the configuration menus:
•
SET UP
menus can only be accessed from manual control. To transfer the
535-PROF from automatic to manual control, press
MANUAL
.
•
To access the
SET UP
menus, hold down
FAST
and press
MENU
until
CONFIG appears in the 2nd display. The
MENU
key will also illuminate.
•
To access the parameters for a particular menu, press
MENU
.
•
To select a parameter value, use and . Press
MENU
to advance to the
next parameter, or
FAST+MENU
to advance to the next menu.
•
To advance to the next menu, press
FAST+MENU
.
•
TUNING
mode (and the
TUNING
menu) can be accessed from either auto-
matic or manual control. To access the tuning menu, press
MENU
.
•
RECIPE SET UP
mode (and the
RECIPE #
menu) can be accessed from
either automatic or manual control.
•
To access the
RECIPE #
menu, press
FAST+MENU
.
•
To return controller to manual control, press
DISPLAY
or
SET PT
.
Access Set Up
Return to Operation
Next menu
Next parameter
Next value
Access Tuning
Return to Operation
+
FAST
MENU
+
FAST
MENU
MENU
▲
▼
MENU
DISPLAY
Figure 5.3
Independent vs. Dependent
Parameters
TUNE PT.
AUTOMATIC
CONTACT 1
MANUAL
A key to these functions (as shown below) appears at the bottom of every page
in the menu section of this chapter.
WHERE TO GO NEXT
•
For information about all the software menus and parameters, continue read-
ing this chapter. Refer to Appendix D for a quick-reference flowchart of all
menus and parameters.
•
For information about the installed options on the 535-PROF, compare the
product label on top of the controller to the order code in Chapter 1.
•
To mount the controller and configure the wiring of the 535-PROF for inputs
and outputs, see Chapter 3.
•
To alter the output module and jumper configuration of the controller, see
Chapter 4.
DISPLAY
