Mitsubishi Melsec-Q QD75D1, Руководство пользователя

Страница: 757 / 858

Appendix - 71
MELSEC-Q
APPENDICES
Appendix 10 When using GX Works2
The following shows the procedure for positioning operation when GX Works2 is used.
( GX Works2 Version1 Operating Manual (Common))
( GX Works2 Version1 Operating Manual (Common))
( Appendix 10.1 Adding a module)
( Appendix 10.2 Setting parameters,
Appendix 10.3 Setting auto refresh)
( CHAPTER 6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL)
Start
Starting operation
End
Configure parameters
and positioning data with
GX Works2?
YES
NO
Starting GX Works2
Start GX Works2.
Creating a new project
Create a new project.
Adding a module
Add a module for the project.
Setting parameters and auto refresh
Configure each setting with GX Works2.
Programming and debugging
Create and debug a program.
Creating programs for parameters and data
Create programs to set parameters and data.
Writing data to flash ROM
Write data to the flash ROM.
Testing and tracing
Test operation and trace waveform and
location of positioning.
Monitoring
Monitor the operating status of the QD75.
( Appendix 10.9 Execution data backup function)
( Appendix 10.4 Positioning monitor)
( Appendix 10.5 Positioning test,
Appendix 10.6 Wave trace,
Appendix 10.7 Location trace)
( CHAPTER 6 SEQUENCE
PROGRAM USED FOR
POSITIONING CONTROL)
For details on the operation method of GX Works2, refer to the following.
GX Works2 Version1 Operating Manual (Common)
For details on operation in GX Works2 for the QD75, refer to the following.
GX Works2 Version 1 Operating Manual (Intelligent Function Module)